This link leaves the site.

Haas Class Descriptions

Haas Operator and Programming training is provided for new machines purchased from Productivity. 

Training for machines not purchased through Productivity can be quoted for you by contacting Productivity’s Training Coordinator, Jen Picken at jpicken@productivity.com or 763.742.1262.

In order to provide training on a timely basis for everyone, we ask that you register no more than 2 people per class session.

MILL CLASS DESCRIPTIONS
Mill Operator

The one day Mill Operator class is intended for individuals that will setup and run a Haas mill. The course covers use of the Haas NGC control panel,  download and upload of programs, the setting of  tool length offsets, the setting of  work coordinate offsets, production set up and operation of the machine tool. VPS (Visual Programming System) will also be covered.

Class hours: 9:00 am – 4:00 pm

Spindle and Tool Probe

This 1/2 day class is designed for individuals that use Wireless Intuitive Probe System for setting tool/work offset. Calibration of the probe system is reviewed.

Class hours:
Morning session: 9:00 am – 12:00 pm
Afternoon session: 1:00 pm – 4:00 pm

Mill G&M Code Programming

The two day Mill G&M Code Programming class is for individuals that use G-code to program Haas mills.  The course covers program format, linear and circular interpolation, cutter compensation and various canned cycles used for drilling, boring and tapping.         

Class hours: 9:00 am – 4:00 pm

LATHE CLASS DESCRIPTIONS
Lathe Operator

The one day Lathe Operator class is intended for individuals that will setup and run a Haas Lathe. The class covers basic operation of the Haas NGC control panel, production set up and operation of the machine tool, download/upload of programs, and setting of tool geometry/work coordinate offsets.

VPS (Visual Programming System) will also be covered.

Class hours: 9:00 am – 4:00 pm

Lathe G&M Code Programming

The two day Lathe G&M Code Programming class is for individuals that use G-code to program Haas lathes.  The course covers program format, linear and circular interpolation, tool nose radius compensation and various canned cycles used for drilling, turning, boring and threading.

Class hours: 9:00 am – 4:00 pm

Live Tool

The half day Live Tool for Haas Lathes Class is for individuals that have gone through the Haas Lathe Operator Training and will be running a Haas lathe with Live Tooling/Y-Axis.  The course covers use of the Haas Live Tooling and Y-Axis option as well as C-Axis Programming.

Class hours: 9:00 am -12:00 pm

Register for All Classes

Online Ordering