What is the Proper Tool Setting Procedure for Haas Machines? To reduce the incidence of a “CRASH” on your Haas machine, proper tool setting procedures should be used. Using the Z Face Measure Key, if you are not sure you are getting the correct value: Example: The correct value should be Z-15.0000 The value after…
What is the proper break-in procedure on NSK electro spindles? If the spindles have been idle for some time, does the user need to warm them up before use? The NSK iSpeed3 Series is a high-precision, high-speed motor spindle. The following procedure must be followed to ensure proper motor spindle operation and longevity. The grease…
How can I safely get my 3-jaw chuck off my turning center? Lower the pressure down to minimum so actuation is slow. When you are in the middle of the stroke hit E stop. Now remove all bolts but one, leave that one on by a quarter inch and use the chuck wrench to take…
Check out coverage of our Oktoberfest Tool Show Student and Career day on Channel 12 TV – September 2013 Click here to see TV spot.
Manufacturers Midwest News – July 2012 Issue Click here to see article on page 34.
Manufacturers Midwest News – December 2011 Issue Click here to see article on page 37.
Journal of the Minnesota Precision Manufacturing Association (MPMA magazine) – Industry Profile, July/August 2011 Issue Click here to see article.
Productivity Robotics and Automation article. Journal of Minnesota Precision Manufacturing Association (MPMA magazine) – Industry Profile, July/August 2011 Issue Click here to see article.
Click here to see article.
Click here to see article.