This link leaves the site.

Haas Lathe Training – Omaha, NE

 (TL/GT/SL/ST/DS Series)

Productivity offers the following Haas Lathe training in Omaha as basic classes intended for individuals that will setup and run a Haas lathe (TL/GT/SL/ST/DS Models). Operators should have general turning knowledge prior to taking any of the classes. Below are brief descriptions of the courses and what is covered in each class.

Depending on your machine model and configuration, you may select the LOP, LPRO and (if equipped) LTFL. 

*The TL Operator Class is offered once a month, with additional class offerings added if needed. If you have a TL model, you will want to take the TL Operator and LPRO Lathe Programming.  You do NOT have to take them the same week.

*For TL Models, you will want to take the LOP and LPRO classes. You do NOT have to take them the same week. If you have a TL, the IPS (Intuitive Programming System) will be covered in the LOP class.

Please call or email the Omaha Training Coordinator at 402-330-2323 or trainingnebraska@productivity.com with any questions.

 

LOP (For Haas TL/GT/SL/ST/DS* Models)

This 1-day Basic Operator class covers the use of the Haas control panel, download and upload of programs, the setting of tool geometry offsets, the setting of work coordinate offsets, production set up and operation of the machine tool.

*NOTE: If you have a TL, the IPS (Intuitive Programming System) will be covered in this class.

LPRO (For all Haas Lathe Models)

This 2-day Basic Programming class is intended for individuals that use G-code to program Haas lathes.  The course covers program format, linear and circular interpolation, tool nose radius compensation and various canned cycles used for drilling, turning, boring and threading.

PREREQUISITE:  Operator must have completed the Basic Lathe Operator class or equivalent training/experience prior to taking the Lathe Programming class.

Online Ordering