This link leaves the site.

Haas Lathe Training – Minneapolis, MN

 (TL/GT/SL/ST/DS Series)

Productivity Inc. offers the following Haas Lathe training in Minnesota as basic classes intended for individuals that will setup and run a Haas lathe (GT/SL/ST/DS/TL Models). Operators should have general turning knowledge prior to taking any of the classes. Below are brief descriptions of the courses and what is covered in each class.  

Depending on your machine model and configuration, you may select the TL* or LOP**, LPRO and (if equipped) LTFL and BAR (new class starting March, 2016).

*The TL Operator Class is offered once a month, with additional class offerings added if needed. If you have a TL model, you will want to take the TL Operator and LPRO Lathe Programming.  You do NOT have to take them the same week.

Please call or email the Training Coordinator at 763-476-8600 or trainingmn@productivity.com with any questions.

TL (*For TL Series Models)

The 1-day Basic Operator Class is intended for individuals that will setup and run a Haas Tool Room Lathe.  The course covers the use of the Haas control panel, download and upload of programs, the setting of tool geometry, the setting of work coordinate offsets and production set up and operation of the machine tool. The class also covers the IPS (Intuitive Programming System).

LOP (**For Haas GT/SL/ST/DS Models)

This 1-day Basic Operator class covers the use of the Haas control panel, download and upload of programs, the setting of tool geometry offsets, the setting of work coordinate offsets, production set up and operation of the machine tool.

LPRO (For all Haas Lathe Models)

This 2-day Basic Programming class is intended for individuals that use G-code to program Haas lathes.  The course covers program format, linear and circular interpolation, tool nose radius compensation and various canned cycles used for drilling, turning, boring and threading.

PREREQUISITE:  Operator must have completed the Basic Lathe Operator class or equivalent training/experience prior to taking the Lathe Programming class.

LTFL (For Haas SL/ST/DS Models equipped with Live Tooling)

This half-day Live Tool for Haas Lathes Class is intended for individuals that have gone through the Basic Haas Lathe Operator Training and will be running a Haas lathe with Live Tooling/Y-Axis.  The course covers use of the Haas Live Tooling and Y-Axis option as well as C-Axis Programming. The class runs from 8:30 am to 12:00 pm.

PREREQUISITE:  Operator must have completed the Basic Lathe Operator class or equivalent training/experience prior to taking the Live Tooling class.

NEW! Haas BAR Operator (For Haas SL/ST/DS Models equipped with a Haas BARxxxx)

This half-day Haas BAR Operator Class is intended for individuals that have the Haas Bar Feeder installed on their Haas lathe and have gone through the Basic Haas Lathe Operator Training. The course covers use of the Haas BARxxxx, including setup, changing pusher rods and alignment for different diameter stock, installation of spindle liners, bar feeder variables (including G105), integration of bar feed loading with lathe programs, using bar feeder counters and using the bar feeder as a hard stop. The class runs from 1:00 pm to 4:30 pm.

PREREQUISITE:  Operator must have completed the Basic Lathe Operator class or equivalent training/experience prior to taking the Haas BAR Operator class.

Online Ordering